Filter
Top Products
English
- 9
TV
RF cable
Aerial
5
TV
RF cable
Aerial
2
3
4
4
1
2
3
Connecting DVD-VCR to the TV
using the RF Cable
To receive television programmes a signal must
be received from one of the following sources:
• An outdoor aerial.
• An indoor aerial.
• A cable television network.
• A satellite receiver.
1 Remove the aerial or network input cable
from the television.
2 Connect this cable to the 75Ω coaxial jack
marked on the rear of your DVD-VCR.
3 Plug the RF Cable supplied into the jack
on your DVD-VCR.
4 Plug the other end of the RF Cable into the
connector previously used for the aerial on
the television.
TV
• Make sure that both the television and the
DVD-VCR are switched off before connect-
ing the cables.
Note
C
C
onnections
onnections
Connecting DVD-VCR to the TV
using the SCART Cable
You can connect your DVD-VCR to the televi-
sion using the SCART cable if the appropriate
input is available on the television. You thus:
• Obtain better quality sound and pictures.
• Simplify the setting up procedure of your
DVD-VCR.
1 Connect the Aerial Cable.
2 Connect one end of the SCART cable to the
AV1 (EURO AV) jack on the rear of the DVD-
VCR.
3 Plug the other end into the appropriate
connector on the television.
Connecting the Audio Output
Cable
You can connect your DVD-VCR to a Hi-Fi
system. Example: You wish to take advantage of
the quality of your Hi-Fi stereo system when
watching a disc play.
4 Plug the audio output cable into the audio
connectors on the rear of your DVD-VCR.
5 Plug the other end of the audio cable into the
appropriate input connectors on your Hi-Fi
stereo system.
• Regardless of the type of connection chosen,
you must always connect the RF Cable supplied.
Otherwise, no picture will be visible on the
screen when the DVD-VCR is switched off.
• Make sure that both the television and the DVD-
VCR are switched off before connecting the
cables.
Note
XEU ENG 2 27/02/2006 13:35 Page 9