Filter
Top Products
User’s Manual
DVR-4TH/8TH/16TH Series
SPECO TECHNOLOGIES 07/10
168
The keys of the remote control function as the keys of the front panel of the DVR. The only
difference between the remote control and the front panel keys is the “DVR SEL” key. The
DVR Selection key is used to switch control between each DVR.
The remote control can be used to control up to 16 DVRs. To setup the remote control, the
first thing you need to do is to assign a unique DVR Unit ID to each DVR.
Use the front panel of the DVR, and follow this path to change the DVR Unit ID, <Main
Menu> Æ <System Setup> Æ <RS485 Setup> Æ <Unit ID>
Change the DVR Unit ID to any number between 224 and 239, and exit the menu.
After the DVR Unit ID is changed, you will need to setup the “DVR SEL” of the remote
control. Press “DVR SEL”, and then press the Remote Control # immediately to select the
DVR. For example, assuming that you have set the DVR Unit ID to 225, then you should
press “DVR SEL”, and then press “2” immediately. Now, the remote control will only be able
to control the specified DVR. Press “DVR SEL”, and then press the Remote control # to
switch between DVRs.
The ID Table is listed below for your reference.
DVR Unit ID 224 225 226 227 228 229 230 231
Remote Control # 1 2 3 4 5 6 7 8
DVR Unit ID 232 233 234 235 236 237 238 239
Remote Control # 9 10 11 12 13 14 15 16
However, if you would like to escape the single DVR control mode, press “DVR SEL”, and
then press “ESC” to do so.