Filter
Top Products
CHAPTER THREE: TV OPERATION 3.13
OPERATION
Labeling the Channels
Use this feature to assign an easy-to-remember label to any channel (i.e., “CBS”, “ESPN”,
“PBS2”, CNN1”, etc.) A label consists of four fields, where each field is a letter, a num-
ber, “*”, or a blank. When the DISPLAY button is pressed, the channel label will appear
next to the channel number.
1
Press CH or CH to tune to the channel that will be labeled.
2
Press the Menu button.
Press the CH button to
select “Channel”, then
press the VOL + button.
Channel
Antenna : A
ANT/CATV : ANT
Auto Program
Fav. Channel
Fine Tune : 00
Add/Erase
Labeling :
-
-
-
-
3
Press the CH button to
select “Labeling”.
Press the VOL + button to
begin labeling.
The left-most field will be
highlighted.
(Each label has four fields.
See top paragraph.)
Channel
Antenna : A
ANT/CATV : ANT
Auto Program
Fav. Channel
Fine Tune : 00
Add/Erase
Labeling :
-
-
-
-
4
Press the CH or CH
button to select a letter,
a number, or a blank.
(Press the CH or
CH button results in this
sequence: A,B,...Z, blank,
0,1,...9).
Channel
Antenna : A
ANT/CATV : ANT
Auto Program
Fav. Channel
Fine Tune : 00
Add/Erase
Labeling : A
-
-
-
5
Press the VOL + button
switch to the next field,
which will be highlighted.
Select a second letter or
digit pressing the CH or
CH button, as above.
Repeat the process to
select the last two digits.
Channel
Antenna : A
ANT/CATV : ANT
Auto Program
Fav. Channel
Fine Tune : 00
Add/Erase
Labeling : ABC1
▼
Note: You cannot select
“Labeling” in the A/V mode.
Press the Menu button to exit the menu.