Filter
Top Products
English - 42
You can get information about the signal status.
1. Press the D.M
ENU button to display the DTV menu.
2.
Press the ▲ or ▼ button to select "Setup", then press the
ENTER/OK button.
3. Press the ▲ or ▼
button to select "System", then press the
ENTER/OK button.
4. Press the ▲ or ▼ button to select "Signal Information",
then
press the ENTER/OK button.
5. Press the EX
IT button to exit.
If the signal status is poor, the "No signal." message is displayed.
Checking the Signal Information
Move Enter Return
Signal Information
Service: ?
Service ID: 0000
Multiplex: ? (TSID 0000, ONID 0000)
Network: ? (ID 0000)
Bit error level: 10
Signal Strength: 0
Return
To keep your product up-to-date with new Digital Television
features then software upgrades are periodically broadcast
as part of the normal Television signal.
It will automatically detect these signals and display the
software upgrade banner. You are given the option to install
the upgrade.
1. Press the D.M
ENU button to display the DTV menu.
2. Press the ▲ or ▼ button to select "Setup", then press the
E
NTER/OK button.
3. Press the ▲ or ▼
button to select "System", then press the
ENTER/OK button.
4. Press the ▲ or ▼ button to select "Software Upgrade",
then press the ENTER/OK button.
5.
Press the
▲ or ▼
button to select "Software Information",
"Manual Upgrade" or "Satandby Mode upgrade".
Press the ENTER/OK button.
Software Information
Press the ENTER/OK button, then the current software
version is shown. To display the software version
information, press the ENTER/OK button again.
To switch to an alternative version, press the red button.
Press the blue button to reset, activate the upgrade and restart.
Manual U
pgrade
Press the ENTER/OK button to search for new software
from the currently broadcasting channels.
Standby
Mode Upgrade : On/Off
Press the ENTER/OK button. To continue software
upgrade with master power on, Select On by pressing
the ▲ or ▼ button.
45 minutes after entering standby mode, a manual
upgrade is automatically conducted. Since the power
of the unit is turned on internally, the screen may be
on slightly for the LCD product. This phenomenon may
continue for more than 1 hour until the software upgrade
is completed.
6. Press the EX
IT button to exit.
Upgrading the Software
System
Product Information
Signal Information
Software Upgrade
Common Interface
Reset
Software Upgrade
Software Information
Manual Upgrade
Standby Mode upgrade : On
Software Upgrade
Software Information
Manual Upgrade
Standby Mode upgrade : On
Software Upgrade
Software Information
Manual Upgrade
Standby Mode upgrade : On
Move Enter Return
Move Enter Return
Move Enter Return
Move Enter Return
BN68-01169L-00Eng-0731.indd 42 2007-08-17 �� 3:38:58