Filter
Top Products
English-47
After it has been set up properly, your remote control can operate in five different modes:
TV, DVD, Cable, Set-Top Box, VCR. Pressing the corresponding button on the remote control
allows you to switch between these modes, and control whichever piece of equipment you
choose.
The remote control might not be compatible with all DVD Players, VCRs, Cable boxes, and
Set-Top Boxes.
Setting Up the Remote to Operate Your VCR
1. Turn off your VCR.
2. Press the VCR button on your TV’s remote control.
3. Press the SET button on your TV’s remote control.
4. Using the number buttons on your remote control, enter three digits of the VCR code
listed on page 49 of this manual for your brand of VCR. Make sure you enter three digits of
the code, even if the first digit is a “0”.
(If more than one code is listed, try the first one.)
5. Press the POWER
button on the remote control.
Your VCR should turn on if your remote is set up correctly.
If your VCR does not turn on after set up, repeat steps 2, 3, and 4, but try one of the other
codes listed for your brand of VCR.
If no other codes are listed, try each VCR code, 000 through 080.
Note on Using Remote Control Modes: VCR
When your remote control is in “VCR” mode, the volume buttons still control your TV’s
volume.
Setting Up the Remote to Operate Your Cable Box
1. Turn off your cable box.
2. Press the CABLE button on your TV’s remote control.
3. Press the SET button on your TV’s remote control.
4. Using the number buttons on your remote control, enter three digits of the cable box
code listed on page 50 of this manual for your brand of cable box. Make sure you enter
three digits of the code, even if the first digit is a “0”. (If there is more than one code listed,
try the first one.)
5. Press the POWER
button on the remote control.
Your cable box should turn on if your remote is set up correctly.
If your cable box does not turn on after set up, repeat steps 2, 3, and 4, but try one of the
other codes listed for your brand of cable box. If no other codes are listed, try each code,
000 through 046.
Note on Using Remote Control Modes: Cable Box
When your remote control is in “CABLE” mode, the volume buttons still control your TV’s
volume.
Setting Up Your Remote Control
BN68-01007U-01Eng.indd 47BN68-01007U-01Eng.indd 47 2006-09-07 11:20:352006-09-07 11:20:35