Filter
Top Products
Setting Up Your Remote Control
English-61
Setting Up the Remote to Operate Your Cable Box
1 Turn off your cable box.
2 Press the SELECT button and make sure that the Cable LED is
illuminated.
3 Press the SET button on your TV’s remote control.
4 Using the number buttons on your remote control, enter three digits
of the cable box code listed on page 63 of this manual for your
brand of cable box. Make sure you enter three digits of the code,
even if the first digit is a “0”.
If there is more than one code listed, try the first one.
5 Press the Power button on the remote control.
Your cable box should turn on if your remote is set up correctly.
If your cable box does not turn on after set up, repeat steps 2, 3, and
4, but try one of the other codes listed for your brand of cable box. If no
other codes are listed, try each code, 000 through 077.
Note on Using Remote Control Modes: Cable Box
When your remote control is in “Cable Box” mode, the volume
buttons still control your TV’s volume.
POWER
P.MODETV SELECT
PRE-CH
-/--
MUTE
P
VIDEO
TTX/MIX
INFO
EXIT
MENU
STILL
S.MODE
ENTER
DUAL I-II
SURROUND
BN59-00373
123
456
789
0
BN59-00373A
SET RESET
P.SIZE SLEEP PIP
DNIe PC
SWAP P
REW STOP
PLAY/PAUSE FF
BN68-448D-03Eng 10/29/03 1:09 AM Page 61