Filter
Top Products
156
System
8
8 System
8.11.4 Auto Power
Enabling this option will automatically power on the product if the power cable is connected.
8.11.5 Standby Control
You can set the screen standby mode to be applied when an input signal is received.
z Auto
Power-saving mode will activate if no input signals are detected even though a source device is
connected to the display.
The message "No Signal" will appear if no source device is connected.
z On
Power-saving mode will activate if no input signals are detected.
z Off
The message "No Signal" will appear if no input signals are detected.
The Standby Control option is only enabled when Source is set to PC or DVI.
If "No Signal" is displayed although a source device is connected, check the cable
connection. Refer to page 53 for details about connecting source devices.
8.11.6 Lamp Schedule
Enables the lamp value to be adjusted to a user-specified value at a specified time in MDC mode.
8.11.7 OSD Display
Displays or hides a menu item on the screen.
z Source OSD / No Signal OSD / MDC OSD
8.11.8 Power On Adjustment
You can set the warm-up time for the screen to turn on after the power button is pressed. (Range: 0 – 50
seconds)
A warm-up time that is too short may damage the product due to overvoltage.
8.11.9 Temperature Control
z Temperature Control
This function detects the internal temperature of the product. You can specify the temperature range
that is acceptable.
The default temperature is set to 77 C.
The recommended operating temperature for this product is 75 to 80 C (based on an ambient
temperature of 40 C).
The screen will become darker if the current temperature exceeds the specified temperature limit. If
the temperature continues to rise, the product will power off to prevent overheating.