Filter
Top Products
37
Using "PCoIP"
2
2 Using "PCoIP"
The OSD configuration options are a subset of the options available in the Administrative Web Interface.
To make changes to the configuration settings, you will need an administrator password. You do not
need a password to view the Diagnostic and Information menus. Applicable only when the Password
item is available.
Network Tab
You can configure the host and client network settings from the Initial Setup page or Network page.
After you update the parameters on this page, click Apply to save your changes.
The Network parameters can also be configured using the Administrative Web Interface.
Figure 2-3: Network Configuration
z Enable DHCP
When Enable DHCP is enabled, the device will contact a DHCP server to be assigned an IP
address, subnet mask, gateway IP address and DNS servers. When disabled, the device requires
these parameters to be set manually.
z IP Address
The IP address of the device. If DHCP is disabled, you must set this field to a valid IP address. If
DHCP is enabled, you cannot edit this field.
z Subnet Mask
The subnet mask of the device. If DHCP is disabled, you must set this field to a valid subnet mask. If
DHCP is enabled, you cannot edit this field.
It is possible to configure an illegal IP address/subnet mask combination (e.g., invalid mask)
making the device unreachable. Ensure you set the subnet mask properly.