Filter
Top Products
C
HAPTER THREE: TV OPERATION
3.9
3
The TV will begin
memorizing all of the
available channels.
After all the available
channels are stored, the
Auto program menu reap-
pears. Press the Menu
button to exit.
OPERATION
Storing Channels in Memory (Automatic Method)
▼
The TV automatically cycles
through all of the available chan-
nels and stores them in memory.
This takes about one to two min-
utes.
2
Press the CH button to
select “Auto Program”, then
press the VOL + button.
Channel
Antenna : A
ANT/CATV : ANT
Auto Program
Fav. Channel
Fine Tune : 00
Add/Erase
Labeling :
-
-
-
-
1
First, select the correct
signal source (ANT, STD,
HRC, IRC). See steps 1~2
on previous page.
Press the Menu button.
Press the CH button to
select “Channel”, then
press the VOL + button
Channel
Antenna : A
ANT/CATV : ANT
Auto Program
Fav. Channel
Fine Tune : 00
Add/Erase
Labeling :
-
-
-
-
2
Press the Add/Erase button:
Repeatedly pressing this button will alternate between
“Added” and “Erased.”
Press the Menu button to exit.
You can view any channel (including an erased channel) by using the number
buttons on the remote control.
1
Use the number buttons to directly select the channel
that will be added or erased.
Adding and Erasing Channels (Manual Method)
00054A-02-CHAPTER 3 2004/10/19 01:05 PM Page 9