Filter
Top Products
Storing Channels in Memory (Automatic Method)
First, select the correct signal source (“Air”, “STD”, “HRC” or “IRC”) as
described on the previous page.
1
Press the MENU button.
Press the … or † button to select
“Channel”, then press the ENTER button.
2
Press the … or † button to select “Auto
Program”, then press the ENTER button.
Press the ENTER button to start the auto
program.
The TV begins memorizing all of the
available stations.
Press the ENTER button at any time to
interrupt the memorization process.
Press the EXIT button to exit.
Adding and Erasing Channels
You can add channels that were not memorized or delete unwanted channels
from memory.
1
Press the MENU button.
Press the … or † button to select
“Channel”, then press the ENTER button.
2
Press the … or † button to select
“Add/Delete”, then press the ENTER
button.
Repeatedly pressing the ENTER button will
alternate between add channel and delete
channel.
Press the CH or CH button (or
number buttons) to switch to the
appropriate channel, then repeat above.
Press the EXIT button to exit.
Alternate method
Simply press the ADD/DEL button on the remote control to add or delete channels.
29
Operation
28
Memorizing the Channels
Your TV can memorize and store all of the available channels for both “off-air” (antenna) and
cable channels. After the available channels are memorized, use the CH and CH buttons to
scan through the channels. This eliminates the need to change channels by entering the channel
digits. There are three steps for memorizing channels: selecting a broadcast source, memorizing
the channels (automatic) and adding/deleting channels (manual).
Channel
Antenna : Ant.1
√
Air/CATV : Air
√
Auto Program
√
Add/Delete
√
Favorite Channels
√
Name
√
Fine Tune
√
▼ More
Move Enter Return
Input
Picture
Sound
Channel
Setup
Channel
Antenna : Ant.1
√
Air/CATV : Air
√
Auto Program
√
Add/Delete
√
Favorite Channels
√
Name
√
Fine Tune
√
▼ More
Move Enter Return
Input
Picture
Sound
Channel
Setup
1
Press the MENU button.
Press the … or † button to
select “Channel”, then press
the ENTER button.
2
Press the … or † button to
select “Air/CATV”, then
press the ENTER button.
If you are connected to an
antenna, press the … or †
button to select “Air”.
If you connected cable,
press the … or † button to
select the type of cable
system: “STD”, “HRC” or
“IRC”.
Press the EXIT button to exit.
NOTES
• “STD”, “HRC” and “IRC” identify various types of cable TV
systems. Contact your local cable company to identify the type
of cable system that exists in your particular area. At this point
the signal source has been selected. Proceed to “Storing
Channels in Memory”.
• Subscription cable services require service-specific requirement
for viewing.
Channel
Antenna : Ant.1
√
Air/CATV : Air
√
Auto Program
√
Add/Delete
√
Favorite Channels
√
Name
√
Fine Tune
√
▼ More
Move Enter Return
Input
Picture
Sound
Channel
Setup
Channel
Antenna : Ant.1
Air/CATV : Air
Auto Program
Add/Delete
Favorite Channels
Name
Fine Tune
▼ More
Move Enter Return
Input
Picture
Sound
Channel
Setup
Aire
STD
HRC
IRC
Start
Enter
Auto Program
Return
Air 12 Not In Memory
Change
Add/Delete
Enter Return
Add
Selecting the Video Signal Source
Before your TV can begin memorizing the available channels, you
must specify the type of signal source that is connected to the TV
(i.e., an antenna or a cable system).
BP68-00283A-02(24~45) 5/6/04 11:33 AM Page 28