Filter
Top Products
English-16
OPERATION
Memorizing the Channels
Your TV can memorize and store all of the available channels for both “off-air” (antenna)
and cable channels. After the available channels are memorized, use the CH and CH
buttons to scan through the channels. This eliminates the need to change channels by
entering the channel digits. There are three steps for memorizing channels: selecting a
broadcast source, memorizing the channels (automatic) and adding and deleting channels
(manual).
Selecting the Video Signal-source
Before your television can begin memorizing the available channels, you must specify the
type of signal source that is connected to the TV (i.e., an antenna or a cable system).
1
Press the MENU button
to display the menu.
Press the
UP/DOWN buttons
to select “Channel”, then
press the ENTER
button.
2
Press the ENTER button
to cycle through these
choices:
Air, STD, HRC, or IRC
(all cable TV).
Press the UP/DOWN
buttons to select the Video
signal source, then press
the ENTER button.
Press the EXIT button to
exit.
Note : STD, HRC and IRC identify various types of cable
TV systems. Contact your local cable company to identify
the type of cable system that exists in your particular area.
At this point, the signal source has been selected.
Proceed to “Storing Channels in Memory” (next page).
BN68-00870A-00Eng 2.qxd 1/15/04 12:49 AM Page 16