Filter
Top Products
English-17
OPERATION
3
Press the ENTER
button.
The TV will begin
memorizing all of the
available channels.
The TV automatically cycles
through all of the available
channels and stores them in
memory. This takes about one to
two minutes.
Press
ENTER at any time to
interrupt the memorization process
and return to the CHANNEL menu.
2
Press the
UP/DOWN buttons
to select “Auto Program”.
Press the ENTER
button.
1
First, select the correct
signal source (Air, STD,
HRC, IRC). See steps
1~2 on previous page.
Press the MENU button.
Press the
UP/DOWN buttons
to select “Channel”, then
press the ENTER
button.
4
After all the available
channels are stored,
the Auto Program menu
reappears.
Press the EXIT button
to exit.
Ex) Press to select channel 108.
Press the CH
/
buttons.
Only the channels stored in memory are selected.
Storing Channels in Memory (Automatic Method)
To check the channels stored in memory
To select channels over 100
Note: You can also press the
AUTO PROG. button to select
available channels.
BN68-00870A-00Eng 2.qxd 1/15/04 12:49 AM Page 17