Filter
Top Products
CHAPTER FOUR
Special Features
4
4
4.20
Programming the Remote Control for Other Components
The remote control has been pre-programmed to operate your Set-Top Box.
However, you can program the remote control to operate other components, such as a cable TV, a VCR,
a DVD player, etc. (even though they are made by different manufacturers).
1
Press the appropriate button among the Component Selection buttons
to activate another component (STB, TV, VCR, CATV, DVD).
For example, if you want to program the remote control to operate
your VCR, press the VCR button on the remote control.
2
Press the SET button on the remote control. The LED for the active
component will light for 30 seconds.
Use the number buttons to enter the code by manufacturer. (See tables
on pages 4.20~4.22)
Each code must be three digits long.
For example, to enter the code “6,” press 0, 0, and 6.
To enter the code “76,” press 0, 7, and 6.
See the remote control code tables on the following pages to find the
appropriate code for your particular component. If more than one
number is listed, try each one separately until you find the one that
works.
MD68-00278A(E)-CHAPTER 4 8/26/02 2:50 PM Page 20