Filter
Top Products
14
GB
Connecting Your VCR to the TV
To receive television programs from an over-the-air or cable
television network, a signal must be received from one of the
following sources.
◆
An outdoor antenna.
◆
An indoor antenna.
◆
A cable television system.
☛ Make sure that both the television and the VCR are
switched off
before connecting the cables.
1 Remove the 75Ω coaxial cable from the television.
2 Connect this cable to the 75Ω coaxial socket marked on the
rear of your VCR.
3 Plug the coaxial cable supplied into the socket on your VCR.
4 Plug the other end of the coaxial cable into the connector
previously used for the antenna on the television.
5 Connect one end of the RCA cable supplied to the output jacks
(OUT1 or OUT2) on the rear of the VCR.
➢ Respect the color coding of the Audio and Video In/Out
cable.
6 Connect one end of the SCART cable to the EURO AV socket on
the rear of the VCR.
7 Plug the other end (of the RCA cable or SCART cable) into the
appropriate connector on the television.
◆ Regardless of the type of connection chosen, you must
always connect the coaxial cable supplied. Otherwise, no
picture will be visible on the screen when the VCR is
switched off.
* NOTICE:
Use the supplied RF adaptors as needed when making RF
connections.
[NTSC/PAL-M Region]
TV
VIDEO
TV
VIDEO
V
TV
VIDEO
OUT
2
R
L
AUDIO
OUT
1
R - AUDIO - L VIDEO
LINE 2 IN
EURO AV
TV
TV
2
3
6
VIDEO
OUT
2
R
L
AUDIO
OUT
1
R - AUDIO - L VIDEO
LINE 2 IN
EURO AV
TV
5
00575A)SV-7000W-GB-1 11/19/99 3:45 PM Page 14