Filter
Top Products
19
GB
Setting the RF OUT CHANNEL
The initial setting of the RF OUT channel is off.
In order to view signals from the RF out connector on your TV, you
must set the RF OUT channel on the VCR to match the TV channel.
1 Press MENU on the remote control.
Result
: The programming menu is displayed.
2 Press the or buttons to select installation.
Result
: The installation MENU is displayed.
3 Press the or buttons to select MANUAL SET UP.
Result
: The MANUAL SET UP menu is displayed.
4 Press the button until the cursor is placed in front of
RF OUT CHANNEL.
5 Press the or buttons to change the RF OUT CHANNEL.
Result
: The RF OUT CH is changed.
➢ Your VCR RF out channel may need to be changed if
there is no picture or the picture suffers from interference.
For better picture and sound quality, connect your VCR to
the TV using the RCA cable (if the appropriate RCA input
is available on your TV).
**
INSTALLATION
**
COUNTRY
ANT./CATV:ANTENNA
AUTO SET UP
¨
MANUAL SET UP
¹
¨
END:(MENU)
**
MANUAL SET UP
**
GUIDE CH SET UP
CH ADD/DELETE
RF OUT M/G/I/K :M
¨
RF OUT CH 14-69:OFF
116-125
¹
¨
END:(MENU)
00575A)SV-7000W-GB-2 11/19/99 3:45 PM Page 19