Samsung TX P2670WH CRT Television User Manual


 
30
OPERATION
Storing Channels in Memory
Press the ENTER button at any
time to interrupt the memorization
process and return to the Channel
menu.
Note: The TV must be connected to
an antenna in order to receive digital TV
signals.
Even if a particular channel is deleted from
the memory, you can always tune to that
channel directly by using the number
buttons on the remote control.
Note: When Receiving a Digital Cable
Signal : If your cable service signal does not
comply with the ATSC(Advanced Television
System Committee) requirements, this prod-
uct may not operate properly.
6
Press the ENTER button
when channel memoriza-
tion is completed.
5
Press the or button
to select the antenna to
memorize, then press the
ENTER button.
The TV will begin memo-
rizing all of the available
channels.
Adopts QAM for transmission
Yes
No
T V Auto Program
Select the antennas to memorize
ANT A + ANT B
ANT A
ANT B
T V Auto Program
Start
Start
Start
Channel Memory in Process
CATV Channel 15
Stop
Auto Program
Stop
16 channel were memorized
Air(ANT A) : 7, Cable(ANT B) : 9
Return
Auto Program
Notes
STD, HRC and IRC identify various types of cable TV systems. Contact your local cable
company to identify the type of cable system that exists in your particular area. At this
point the signal source has been selected. Proceed to “Storing Channels in Memory”.
• Subscription cable services require service-specific requirement for viewing.
When selecting the Cable TV
system:
Press the or button to
select “Cable”, then press
the ENTER button.
Press the or button to
cycle through these choices:
“STD”, “HRC” or “IRC”, then
press the ENTER button.
Select the cable system
STD
HRC
IRC
T V Auto Program
Air None
Cable None
Air Cable
Cable Air
ANT A : Air
ANT A : Cable
ANT A : Air, ANT B : Cable
ANT A : Cable, ANT B : Air
4
Press the or button to
select antenna connection,
then press the ENTER button.
Select the antenna connection
ANT A ANT B
T V Auto Program
Air None
Cable None
Air Cable
Cable Air