Filter
Top Products
70_ main menu
main menu
SETTING THE EVENT
You can set recording options for sensor, motion, and video loss event.
Setting the <Sensor Detection> is not supported by SDE-4003/5003.
Sensor Detection
You can set the sensor’s operating condition and connected camera, as well as alarm output and its duration.
Using the mouse may help make setup easier.
1. Press the [MENU] button on the remote control or front
panel.
2. Use the left/right button (
◄ ►
) to select <Event>.
Event setting menu is selected.
3. Use the up/down buttons (
) to move to <Sensor
Detection>, and press [ENTER] button.
A window of sensor detection setup appears.
4. Use direction buttons (
◄ ►
) to move to a desired
item, and set the value.
• Sensor Operation : Sets the operation mode of sensors.
-<OFF> : Sensor does not operate.
-<N.O (Normal Open)> : Sensor is opened.
If the sensor is closed, it generates alarm.
-<N.C (Normal Close)> : Sensor is closed.
If the sensor is open by interruption, it generates alarm.
• Cam : Select a channel to be connected to the sensor.
If selected camera, “Camera Setup” window appears.
Select a channel and setup the preset.
SDE-400X could only preset 8 channels.
Event
Logout
Return
Sensor Detection
Motion Detection
Video Loss Detection
Alarm Schedule
Sensor Detection
OK Cancel
Sensor
Sensor Operation
Cam
Alarm
Duration
1 OFF
1 None 10 sec
2 OFF
2 None 10 sec
3 OFF
3 None 10 sec
4 OFF
4 None 10 sec
Sensor Detection
OK Cancel
Sensor
Sensor Operation
Cam
Alarm
Duration
1 OFF
1 None 10 sec
2 OFF
2 None 10 sec
3 OFF
3 None 10 sec
4 OFF
4 None 10 sec
Camera Setup
OK Cancel
CH
1
2
3
4
5
6
7
8
CH
9
10
11
12
13
14
15
16