Filter
Top Products
English _61
● MAIN MENU
SETTING THE EVENT
You can set recording options for motion, and video loss event.
Motion Detection
You can set target detection region and motion, as well as the alarm signal output.
When the motion detection region is set, it detects motion within the area.
Using the mouse may help make setup easier.
1. Press the [MENU] button on the remote control.
2. Use the left/right button (_ +) to select <Event>.
Event setting menu is selected.
3. Use the up/down buttons (▲▼) in <Event> window to
move to <Motion Detection>, and press [ENTER] button.
A window of motion detection area setup appears.
4. Use direction buttons (▲▼_ +) to move to a desired item,
and set the value.
•Mode : Sets whether to activate motion detection.
•Sensitivity : Sets the sensitivity level of the motion detection.
•Alarm : Sets the alarm output method.
`
For further information on alarm output, refer to “HDD Alarm >
Alarm”. (Page 55)
•Alarm Duration : Sets the duration of alarm signal and alarm sound.
5. When the motion detection setup is done, press <OK>.
Event
Logout
Return
Motion Detection
Video Loss Detection
Tampering Detection
Alarm Schedule
Motion Detection
OK Cancel
Previous/Next Page
CH Mode
Sensitivity
Alarm
Alarm Duration
1 OFF
Level10(High)
None 10 sec
2 OFF
Level10(High)
None 10 sec
3 OFF
Level10(High)
None 10 sec
4 OFF
Level10(High)
None 10 sec
5 OFF
Level10(High)
None 10 sec
6 OFF
Level10(High)
None 10 sec
7 OFF
Level10(High)
None 10 sec
8 OFF
Level10(High)
None 10 sec
Motion Region