Filter
Top Products
3.2 CHAPTER THREE:OPERATION
OPERATION
Up/Down
L/R
Menu
±
Please, use remote control
R
4
While “Red” is highlighted (letters are
blue color), press the VOL+ button:
A crosshair pattern will appear on the
screen. If either a vertical or a
horizontal red line is visible, then the
convergence needs alignment.
Up/Down
L/R
Menu
±
Please, use remote control
R
5
If a horizontal red line is
visible, use CH▲ and CH▼ buttons
to move the line so that it is super-
imposed on the horizontal center-
line (i.e., make a single horizontal
line that is as white as possible.)
Up/Down
L/R
Menu
±
Please, use remote control
R
6
If a vertical red line is visible, use
the VOL + and VOL - buttons to
move the line so that it is superim-
posed on vertical-center line (i.e.,
make a single vertical line that is as
white as possible.)
Adjust Red Convergence
Move Ent. Menu
±
SET UP
Manual convergence
Red
Blue
7
At this point, the Red convergence
is correctly adjusted. Press MENU,
then press the CH▼ button once to
highlight the word “Blue.”
Up/Down
L/R
Menu
±
Please, use remote control
B
8
While the word “Blue” is highlight-
ed, press the VOL+ button to adjust
the blue convergence. When the
crosshair pattern appears, use
CH▲ and CH▼ and VOL + - to
converge the blue line (same
procedure as in steps 1~7, above).
Adjust Blue Convergence
9
After the blue convergence is
correctly adjusted, press MENU four times to exit all the menus.
01791A(E)-CHAPTER 3 11/10/05 10:40 AM Page 2