Filter
Top Products
3
Press VOL + again.
The TV will begin
memorizing all of the
available channels.
4
After all the available
channels are stored, the
Auto program menu
reappears. Press Menu
three times to exit.
3.6 CHAPTER THREE: TV OPERATION
OPERATION
Storing Channels in Memory (Automatic Method)
▼
The TV automatically cycles
through all of the available channels
and stores them in memory. This
takes about one to two minutes.
Press VOL+ at any time to interrupt
the memorization process and return
to the Setup menu.
2
Press VOL + while
“Channel set up” is high-
lighted. A new sub-menu
will appear, and “Auto
program” will be
highlighted.
Move Ent. Menu
±
SET UP
Auto program
Fine tune
LNA
00
Off
1
First, select the correct
signal source (ANT, STD,
HRC, IRC). See steps 1~4
on previous page.
Press MENU, then press
CH ▼ twice to highlight
“SET UP.”
Press VOL + to access
the SETUP sub-menu.
“Channel set up” will be
highlighted.
Move Ent. Menu
±
SET UP
Channel set up
ANT / CATV
Time
Convergence
Language
Caption
V-chip
ANT
English
Auto program
ANT 4
ANT 11
+: Stop
Note: Channel auto program does not function when the
V-chip is active.
01791A(E)-CHAPTER 3 11/10/05 10:40 AM Page 6