Filter
Top Products
2.4 CHAPTER TWO: INSTALLATION
Splitter
Incoming
Cable
Cable Box
RF (A/B)
Switch
A
B
IN CABLE OUT
4
Connect a coaxial cable
between the ANTENNA
OUT terminal on the
cable box and the B–IN
terminal on the A/B
switch.
RF (A/B)
Switch
A
B
Splitter
Incoming
Cable
Cable Box
IN CABLE OUT
5
Connect another cable
between the other OUT
terminal on the splitter
and the A–IN terminal
on the RF (A/B) switch.
75
VHF/UHF
Splitter
Incoming
Cable
Cable Box
RF (A/B)
Switch
TV Rear
A
B
IN CABLE OUT
6
Connect the last coaxial
cable between the OUT
terminal on the RF (A/B)
switch and the VHF/UHF
terminal on the rear of
the TV.
INSTALLATION
Connecting a VCR
These instructions assume that you have already connected your TV to an antenna or a cable
TV system (according to the instructions on pages 2.1-2.3). Skip step 1 if you have not yet
connected to an antenna or a cable system.
After you’ve made this connection, set the A/B switch to the “A” position for normal viewing.
Set the A/B switch to the “B” position to view scrambled channels. (When you set the A/B
switch to “B,” you will need to tune your TV to the cable box’s output channel, which is usu-
ally channel 3 or 4.)
1
Unplug the cable or
antenna from the back
of the TV.
Incoming
Cable or
Antenna
VCR Rear Panel
VIDEO
OUT
AUDIO
OUT
LR
IN
OUT
ANTENNA
2
Connect the cable or
antenna to the
ANTENNA IN terminal
on the back of the VCR.
01791A(E)-CHAPTER 2 11/10/05 10:40 AM Page 4