Filter
Top Products
GB
Deck Control Keys
15
Tuning Your Television for the DVD-VCR
GB
14
The DVD-VCR uses one set of controls to operate both decks. The
following keys are helpful in successfully controlling each deck.
1 STANDBY/ON Button
Press the STANDBY/ON button on the remote control or front
panel to turn on the DVD-VCR.
2 DVD Button
Press the DVD button on the remote control when you want to
control the DVD deck.
◆ The DVD indicator will light on the Front Panel Display to show
that the DVD deck is selected.
3 VCR Button
Press the VCR button on remote control when you want to control
the VCR deck.
◆ The VCR indicator will light on the Front Panel Display to show
that VHS deck is selected.
4 DVD-VCR Toggle
Press the SELECT button on the front panel to toggle control
between the DVD deck and the VCR deck.
➢ Before using the VCR operation of 19~41 pages, press
the VCR button on the remote control to select VCR
mode.
Before using the DVD operation of 42~62 pages, press
the SELECT button on the remote control to select and
watch DVD.
STANDBY/ON
1
2
4
5
SHUTT
STANDBY/ON
AUDIO
MODE/
REPEAT
1
0
3D SOUND SCREEN FIT CLEAR
DVD VCR INPUT SEL.
VIEW
TRK PROG
DISPLAY
F.ADV/STEP
DIGEST
SVHS
A.TRK
SELECT COPY
R
OG REC
EJECT
AUX
2
3
4
You must tune your television for the DVD-VCR only if you are not
using a RCA cable
➢ To view pictures from your DVD-VCR when a RCA cable
is used, the television must be set to the audio/video
mode (AV).
1 Switch on the television.
2 Switch on the DVD-VCR by pressing STANDBY/ON on the front of
the DVD-VCR or STANDBY/ON on the remote control.
3 Select a programme position on the television to be reserved for
use with your DVD-VCR.
4 Insert the video cassette in the DVD-VCR. Check that the
DVD-VCR starts reading the cassette; if not, press
❿
II
button
.
5 Start a scan on your television or set the television to UHF
channel 36.
6 Fine tune the television until the pictures and sound are obtained
clearly.
7 If you cannot find the pictures and sound, or there is interference
from nearby channels, it may be necessary to change the setting
of the DVD-VCR output channel (see Setting the DVD-VCR
Output Channel on page 23 and Problems and Solutions on page
66).
8 When the picture and sound are perfectly clear, store this channel
at the desired programme position on the television.
Result: That programme is now reserved for use with your
DVD-VCR.
REC
DISC MENU
SETUP
/ENTER
2
3
4
5
6
SHUTTLE
STANDBY/ON OPEN/CLOSE
AUDIO
MODE/
REPEAT
TV/VCR
CLOCK/
COUNTER
4
2