Filter
Top Products
Install Manual
42
- Stranded wire: Strip 8 ~ 10㎜ of insulation off the end of the wire and solder it together. Use
AWG 22 ~ 26 wire.
- Solid wire: Strip 8 ~ 10㎜ of insulation off the end of the wire. Use AWG 20 ~ 26.
3.3.2 Wire insertion/removal
When inserting/removing wires to/from the terminal block, push the driver as shown below and
insert or remove the wire.
3.3.3 Sensor connections & settings
3.3.3.1 Specification
The sensor specifications are as follows.
Specification
No. of inputs 16 transistor input
Input types N.C, N.O support
Support Sensor Dry contact sensor
Connection method Insert stripped wire end into terminal block
Electric
capacity
Pulse width of usable
input
Minimum 500ms
Output power Typical DC 12mA