Samsung SVR-960C DVR User Manual


 
User Manual
85
Remote Controller ID
Up to 16 remote controller IDs can be set. You can use one remote controller to operate up to
16 DVRs.
How to register the remote controller is as shown below.
- Direct the remote controller to the DVR.
- Press the [ID] button based on the specified remote controller ID.
- If the remote controller ID and the DVR ID are the same, the DVR buzzer beeps.
- The remote controller is now configured and available for use.
Remote Configuration Setup
This determines whether to use the SNM Configuration program for setup.
If "Enable" is set, SNM Configuration is available for setup. If "Disable" is set, SNM
Configuration is unavailable for setup.
Remote Relay
Remote Relay is used to determine whether to use the Relay On/Off function on the SNM
monitor.
If "Enable" is set, all four relays can be controlled remotely. If "Disable" is set, remote
control is unavailable with the SNM Configuration.
6.8.4.1 Serial Port
A total of four serial ports are available for the DVR. Two are RS-232C(Com1, Com3) and the
other two are RS-422/485(Com2, Com4).
The Serial Port settings are available under Communication > Remote.
The following options are provided for the Serial Port settings.
A total of 3 serial ports are available for SVR-480. One is RS-232C(Com1), and the other
two are RS-485(Com2,3).