Filter
Top Products
INSTALLATION
English - 15
Connecting a VCR
These instructions assume that you have already connected your TV to an antenna or a
cable TV system (according to the instructions on pages 11~14).
• Please be sure to match the color coded input terminals and cable jacks.
1
Connect a coaxial cable between the
“VHF/UHF” terminal on the TV and the antenna
out terminal on the VCR.
A coaxial cable is usually included with a
VCR. (If not, check your local electronics
store).
2
Connect a set of audio cables between the
“AV IN 1 (L, R)” (or “AV IN 2 (L, R)”) jacks on
the TV and AUDIO OUT jacks on the VCR.
If you have a mono VCR, connect L(mono) to
VCR audio out using only one audio cable.
3
Connect a video between the “AV IN 1 (VIDEO)”
“AV IN 2 (VIDEO)” jack on the TV and the VIDEO
OUT jack on the VCR.
Refer to your VCR’s instructions for more
information about how to view your VCR
tape.
•Also, you can connect to “AV IN 2” on the side panel of TV.
Connecting a Second VCR to Record from the TV
Your TV can send out signals of its picture and sound to be recorded by a second VCR.
To do this, connect your second VCR as follows:
1
Connect a set of audio cables between the
“AV OUT (L, R)” jacks on the TV and AUDIO IN
jacks on the VCR.
The VCR input jacks might be either on the
front or on back of the VCR.
2
Connect a video cable between the “AV OUT
(VIDEO)” jack on the TV and the VIDEO IN jack
on the VCR.
Refer to your VCR’s instructions for more
information about how to record using this
kind of connection.
1
2
1
2
3
AA68-03780A-00Eng_US 4/27/06 3:57 PM Page 15