Filter
Top Products
English-17
Storing Channels in Memory (Automatic Method)
1.
Press the
MENU
button to display the menu.
Press the
or
button to select “Channel”, then press the
ENTER
button.
2.
Press the
or
button to select “Auto Program”, then press the
ENTER
button.
3.
Press the
or
button to select the antenna connection, then press the
ENTER
button.
➢
Air: “Air” antenna signal.
Cable: “Cable” antenna signal.
Air+Cable: “Air” and “Cable” antenna signals.
➢
If the antenna is connected to ANT 1 IN (AIR), select “Air” and if it is connected to ANT
2 IN (CABLE), select “Cable”.
➢
If both ANT 1 IN and ANT 2 IN are connected, select the “Air + Cable”.
➢
If you selected “Air”, then go to step
5
.
4.
Select the correct signal source (STD, HRC, and IRC) by pressing the
ˇ
button,
then press the
or
button.
Press the
ˆ
button to select “Start”, then press the
ENTER
button.
➢
STD, HRC, and IRC identify various types of cable TV systems. Contact your local
cable company to identify the type of cable system that exists in your particular area. At
this point the signal source has been selected.
5.
After all the available channels are stored, the “Auto Program” menu reappears.
Press the
EXIT
button to exit.
You can also press the AUTO PROG. button on the remote control to bring up the
Auto Program menu.
Channel
Antenna : Air
ˆ
Auto Program
ˆ
Channel Manager
ˆ
Name
ˆ
Fine Tune
ˆ
Signal Strength
ˆ
Move Enter Return
Auto Program
Select the antennas to memorize.
Air
Cable
Air + Cable
Start
Start
Start
Memorizing the Channels
Your TV can memorize and store all of the available channels for both “off-air” (air) and cable channels.
After the available channels are memorized, use the CH or CH button to scan through the channels.
This eliminates the need to change channels by entering the channel digits. There are three steps for memorizing channels:
selecting a broadcast source, memorizing the channels (automatic) and adding and deleting channels (manual).
Selecting the Video Signal-source
Before your television can begin memorizing the available channels, you must specify the type of signal source that is connected to the
TV (i.e. an air or a cable system).
1.
Press the
MENU
button to display the menu.
Press the
or
button to select “Channel”, then press the
ENTER
button.
2.
Press the
ENTER
button select “Antenna”.
Press the
or
button to select “Air” or “Cable”, then press the
ENTER
button.
Press the
EXIT
button to exit.
Channel
Antenna : Air
Auto Program
Channel Manager
Name
Fine Tune
Signal Strength
Channel
Antenna : Air
ˆ
Auto Program
ˆ
Channel Manager
ˆ
Name
ˆ
Fine Tune
ˆ
Signal Strength
ˆ
Air
Cable
Move Enter Return
Move Enter Return
Move Enter Return
Auto Program
Select the cable system.
Analog
Start
Move Enter Return
STD
✔
HRC
IRC
Auto Program in progress.
15%
Air 16
Stop
Auto Program
Enter Return