Filter
Top Products
ENG-11
Deck Control Buttons
The DVD-VCR uses one set of controls to operate both
decks. The following buttons are helpful in successfully
controlling each deck.
1 POWER Button
Press the POWER button on the remote control or
front panel to turn on the DVD-VCR.
2 DVD Button
Press the DVD button on the remote control or
DVD-VCR button on the front panel when you want
to control the DVD deck.
• The DVD indicator will light on the Front Panel
Display to show that the DVD deck is selected.
3 VCR Button
Press the VCR button on the remote control or
DVD-VCR button on the front panel when you want
to control the VCR deck.
• The VCR indicator will light on the Front Panel
Display to show that the VHS deck is selected.
4 INPUT SEL. Button
Press the INPUT SEL. button on the remote control
repeatedly to cycle through all of your input
sources, including the Tuner(Ch##), Line 1 (rear AV
input), and Line 2 (front AV input).
• Input selection is only available when the VCR
deck is selected.
Basic DVD Operation
Follow the instructions below to playback a DVD.
1 Open the Disc Tray
Press the OPEN/CLOSE button on your remote control or
on the front panel of the unit to turn on the power and
open the disc tray.
2 Insert a Disc
Put a disc in the center of the tray, with the label-printed
side facing up.
3 Close the Disc Tray
Press the OPEN/CLOSE button on your remote control or
on the front panel of the unit to close the disc tray.
4 Play a DVD
Press the
ll
(PLAY/PAUSE) button on your remote
control or on the front panel of the unit.
• Most discs will start to playback as soon as the tray
closes.
• If a DVD has a MENU, the menu may pop up on TV
screen.
5 Additional DVD Options
• See pages 16 ~ 21 for advanced DVD Setup options.
• See page 22 for special DVD Playback features.
Basic VCR Operation
To play a standard VHS videotape, just insert it into the
VCR deck and press the PLAY button. You can turn on
the Auto Play to enable the VCR deck to play
automatically when you insert a videotape that is
missing the Record Safety Tab. See page 29.
1 Insert VHS Tape
Insert a standard VHS videotape into the VCR
deck.
• When a videotape is inserted, power will turn on
automatically.
2 Play Tape
Press the ll(PLAY/PAUSE) button on the remote
control or on the front panel of the unit. The
videotape will begin to play automatically if it is
missing the Record Safety Tab and Auto Play is
turned on. See page 29.
3 Stop Playback
Press the
■
(STOP) button on the remote control or
on the front panel of the unit.
4 Additional VCR Options
• See page 28 for special VCR Playback features.
• See pages 30~32 for VCR Recording features.
• See page 32 for Timer Recording features.