Filter
Top Products
19
●
Select CH. Scan Memory and
manually add channels or start
CH. (channel) search.
●
Press RESET key to clear setting.
●
Set V-Guide to OFF or press the
RESET key.
●
Select Caption1 or Caption2
(see page 11).
●
Reselect your menu language
choice using the on-screen menu or
press RESET key.
●
Replace batteries.
●
Aim remote control at front of TV.
●
Re-enter brand code (see page 7).
HELPFUL HINTS - PROBLEMS/ SOLUTIONS (Continued)
BEFORE REQUESTING SERVICE CHECK THE FOLLOWING CHART.
Cannot select or scan
some channels.
No Captioning.
Menu System words
seem misspelled.
Remote Control
will not work.
Remote Control will
not operate VCR and
Cable Box.
Cabinet makes popping
sound.
●
Channel may be removed from
memory.
●
Check antenna connections.
●
V-Guide is set to block program-
ming (see pages 14 and 15).
●
Check if station is broadcasting a
Closed-Caption signal.
●
Check Caption Channel.
●
May be a foreign language is
selected.
●
Check batteries.
●
Check if TV is plugged in.
●
Press TV key.
●
Press VCR or CABLE key.
●
Check external equipment.
●
This is a normal condition during
warm-up and cool down of the
plastic cabinet parts.
Problem: Check these Conditions: Try these Solutions:
This symbol on the nameplate means the product is Listed by Underwriters’
Laboratories Inc. It is designed and manufactured to meet rigid U.L. safety
standards against risk of fire, casualty and electrical hazards.
CARE AND CLEANING
The surface of the cabinet can be damaged if not properly maintained. Many common household aerosol sprays,
cleaning agents, solvents and polishes will cause permanent damage to the fine surface.
1. Unplug the power cord before cleaning the television.
2. Clean the screen and cabinet with a soft dry cloth.
Note: NEVER spray liquids on the screen because they can run
down and drip onto the chassis. This may cause component
failure not covered under Warranty.
●
Select CH. Scan Memory and
manually add channels or start
CH. (channel) search.
●
Press RESET key to clear setting.
●
Set V-Guide to OFF or press the
RESET key.
●
Select Caption1 or Caption2
(see page 11).
●
Reselect your menu language
choice using the on-screen menu or
press RESET key.
●
Replace batteries.
●
Aim remote control at front of TV.
●
Re-enter brand code (see page 7).
HELPFUL HINTS - PROBLEMS/ SOLUTIONS (Continued)
BEFORE REQUESTING SERVICE CHECK THE FOLLOWING CHART.
Cannot select or scan
some channels.
No Captioning.
Menu System words
seem misspelled.
Remote Control
will not work.
Remote Control will
not operate VCR and
Cable Box.
Cabinet makes popping
sound.
●
Channel may be removed from
memory.
●
Check antenna connections.
●
V-Guide is set to block program-
ming (see pages 14 and 15).
●
Check if station is broadcasting a
Closed-Caption signal.
●
Check Caption Channel.
●
May be a foreign language is
selected.
●
Check batteries.
●
Check if TV is plugged in.
●
Press TV key.
●
Press VCR or CABLE key.
●
Check external equipment.
●
This is a normal condition during
warm-up and cool down of the
plastic cabinet parts.
Problem: Check these Conditions: Try these Solutions:
CARE AND CLEANING