Filter
Top Products
3
Connect your aerial cable socket to the back of the TV set. Fit the aerial
cable as shown below or as shown opposite when AV equipment is con-
nected.
Connect the power cord of the TV set to a wall outlet.
✐ The TV set is prepared for a mains voltage AC220~240V, 50Hz.
When the TV set is not to be used for an extended period of time,
it is advisable to disconnect the power cord from the power outlet.
✐ For all aerial problems please consult your local dealer.
● Connecting DVD / VCR player or Satellite receiver.
We recommend that you connect all other equipment before Plug and
Play. The following examples are our recommended standard
connection. For further information please consult your local dealer.
Please refer to individual Instruction Manuals for each piece of equip-
ment for their connection suggestions.
Install two "AA" 1.5 volt batteries so that the "+" and "-" marks on the
batteries match the "+" and "-" marks inside the unit into the remote
control handset.
INST
INST
ALLA
ALLA
TION
TION
Step : 1 Connections ( Essential)
ANT.75Ω
AV1
AV2
AC Mains Outlet
WARNING! High voltages are used in the operation of
this set. Refer service to qualified service personnel.
ANT.75‰
VCR
OUT
IN
OUT
IN
Satellite
VCR
TV
DVD
Option if no DVD
For Satellite
only
DISH
IN
TV rear panel
AV2
AV1
Important:
This equipment is fitted with an approved non rewireable UK mains
plug. To change a fuse in this type of plug proceed as follows:
1. Remove the fuse cover and fuse.
2. Fit a new fuse which should be a BS1362 5Amp A.S.T.A. or BSI
approved type.
3. Ensure that the fuse cover is correctly refitted.
If the fuse cover is lost or damaged the plug must NOT be used but
replaced with a serviceable plug.
If the fitted plug is not suitable for your socket outlets, it should be
cut off and an appropriate plug fitted in its place. If the mains plug
contains a fuse, this should have a rating of 5 Amp, ensure the fuse
cover is correctly fitted. If a plug without a fuse is used, the fuse at
the distribution board should not be greater than 5 Amp.
Note: The severed plug must be destroyed to avoid a possible
shock hazard should it be inserted into a 13Amp socket elsewhere.
The wires in this mains lead are coloured in accordance with the
following code:
Blue -------> Neutral
Brown ----> Live
1. The Blue wire must be connected to the terminal whichis marked
with the letter “N” or coloured BLACK.
2. The Brown wire must be connected to the terminal with the letter
“L” or coloured RED.
3. Do not connect either wire to the earth terminal in the symbol or
coloured GREEN or GREEN and YELLOW.
Before replacing the plug cover, make certain that the cord grip is
clamped over the sheath of the lead - not simply over the wires.
Please make sure that you have read the End-User section on page 2
before you activate Plug and Play.
Step : 2 Remote control battery installation