Filter
Top Products
17
Need help?
Visit our Web site at www.sanyoctv.com or Call 1-800-877-5032
USING THE REMOTE CONTROL
PRECAUTIONS
To ensure safe operation, please observe the following
precautions:
Replace both batteries at the same time. Do not use a new
battery with a used battery.
Risk of explosion, if battery is replaced by an incorrect type.
Do not expose the Remote Control Unit to moisture or heat.
REMOTE CONTROL KEYS
➀
Input Key—Press to change the input signal
source as follows: Analog RF ➡ Digital RF ➡
Video 1 ➡ Video 2 ➡ Video 3 ➡ HDMI ➡
Analog RF.
➁
Number Keys—Two keys must be pressed
to select a direct channel.
Example:
Press 0
then 6 to select channel 6.
For Analog Cable channels above 100,
press and hold the 1 key until C1– –
appears, then press the other two
numbers.
➂
Info Key—Press to display the Digital and
Analog Full Banner information (press again
to remove the display).
Digital Full Banner display—
Contains a two-
part Channel Number (Major and Minor), and
Tuner ID. If available the following is also
included: Station ID, V-Chip Program Rating,
Program Title, Audio Info, and Signal Strength.
Analog Full Banner display—
Contains the
Channel Number (analog antenna/cable),
Tuner ID, Station ID (if available), Program
Title (if available), V-Chip Program Rating, and
Audio Info.
Program Rating
Program Title
Tuner ID
Audio Info
Program Rating
Station ID
Program Title
➀
➁
➂
➠
Point toward
DTV
Channel
Major Minor
Signal Strength
Channel No.
Tuner ID
(Continued on page 18.)
Audio Info
Station ID