Sanyo PDG-DXT10KL Projection Television User Manual


 
1. Introduction
11
ITEM LABEL DESCRIPTION SEE PAGE:
10.
SCREEN
TRIGGER
When connected to the screen through a commercially available
cable, the screen deploys automatically on start up of the projec-
tor. The screen retracts when the projector is powered off
(see notes below)
117
11.
S-VIDEO
Connect a commercially available S-video cable from a video
device
29
12.
POWER SWITCH Turn on/off the projector
41
13.
AC IN Connect the supplied power cable
31
14.
AUDIO IN
[L(MONO)/R]
(VIDEO)
Connect RCA audio cables (not supplied) from the input device
right and left channels. This audio jack is shared with S-Video
input.
15.
VIDEO IN
Connect a composite video cable (not supplied) from a video de-
vice to the yellow RCA jack
30
16.
COMPONENT IN
(Y, Cb/Pb, Cr/Pr)
Connect a component video enabled device
30
17.
COMPUTER 2 IN
(R/Cr, G/Y, B/Cb,
H, V)
Connect RGBHV or Component signal from computer or com-
ponent video enabled device
30
18.
COMPUTER 1 IN Connect a VGA cable (supplied) from a computer
26
19.
AUDIO IN
(COMPUTER 1)
Connect the audio cable (not supplied) from the input device
20.
LAN Connect a LAN cable (not supplied) from a computer
26
21.
SERVICE
Connect the USB cable (not supplied) from a computer. For ser-
vice personnel only.
Note:
y
To use this feature, you must turn on the Screen Trigger function on the OSD.
y
Screen controllers are supplied and supported by screen manufacturers.
y
Do not use this jack for anything other than intended use. Connecting the wired remote control to the
Trigger mini jack causes damage to the remote control.