Sanyo PDG-DXT10KL Projection Television User Manual


 
1. Introduction
15
Operating Range for Wireless Remote Control
Point the remote control toward the projector (to Infrared Remote Re-
ceivers) when pressing the buttons. Maximum operating range for the
remote control is about 16.4 feet (5 m) and 60 degrees in front and rear
of the projector.
Infrared remote receivers are provided both in front and back of the pro-
jector. You can conveniently use both of the receivers.
Remote Control Precautions
The following precautions ensure that the remote operates correctly and
safely.
x Use two (2) AA or LR6 type alkaline batteries.
x Always replace batteries in sets.
x Do not use a new battery with a used one.
x Avoid contact with water or liquid.
x Do not expose the remote control to moisture or heat.
x Do not drop the remote control.
x If the battery has leaked on the remote control, carefully wipe the
case clean and install new batteries.
x Risk of an explosion if battery is replaced by an incorrect type.
x Dispose of used batteries according to the instructions.
Remote Control Codes
This projector provides eight different remote control codes (Code 1–Code 8); the factory-set, initial code (Code 1) and the
other seven codes (Code 2 to Code 8). This switching function prevents remote control interference when operating sev-
eral projectors or video equipment at the same time.
The same code should be set on both the projector and the remote control.
For example operating the projector in “Code 7”, both the projector and the remote control must be switched to “Code 7”.
To change the code for the projector;
Select a remote control code in the Menu.
To change the code for the remote control;
Check the Reset Switch to Use position in the compartment lid on back of the remote control.
With holding down the MENU button, press the IMAGE button. By pressing the IMAGE button, the code switches in a se-
quential order.
To reset the code for the remote control;
Slide the Reset Switch to "Reset position" in the compartment lid on back of the remote control.