Sceptre Technologies E Series Flat Panel Television User Manual


 
- 12 -
www.SCEPTRE.com
SCEPTRE E Series LED HDTV User Manual
Rear View Connections
1. HEADPHONE – This connection is for headphones to be attached to the TV.
2. TV – This connection is for digital or analog cable without the cable box or
over-the-airwave antennas. The tuner is a hybrid tuner that tunes to both
analog and digital channels. This connection uses coaxial RF cable. For
over-the airwave digital stations please check http://www.antennaweb.org
.
3. VGA - This connection port connects to a PC for video using VGA cable. Be
sure to connect your audio cable to the VGA Stereo input if you want sound
out of VGA video source.
4. Audio In - This connection port is for people who want to provide audio to the
TV when using a PC or a DVI video device. The sources use 3.5mm mini-jack
audio cable.
5. YPbPr – This connection port is for DVD players or satellite / cable set-top
boxes that use component cables. From left to right, connect green, blue,
and red for video, and then connect white for left channel audio, and red for
right channel audio. This connection shares audio red / white jacks with
Video.
6. Video – Video connects to devices that use composite video cables such as
VCR or DVD player or Wii™. Connect the yellow for video and the red / white
for audio. This connection shares audio red / white jacks with YPbPr.
7. SPDIF - This connection port is used for sending out digital audio signals to
digital surround sound receivers. The orange (COAX SPDIF OUT) connector
sends out either bit-stream or PCM digital sound signal to a home theater
receiver with digital coax input.