Filter
Top Products
52
Setting up your TV
Storing channels in memory (optional)
❖ You must set up the ANT/CABLE input source before
programming channels. See “ANT/CABLE IN” on page 50.
❖ The automatic channel programming process will erase
channels that were previously programmed into the TV’s
memory.
❖ To tune the TV to a channel not programmed in the channel
memory, you must use the Channel Number buttons on the
remote control.
❖ Programming channels when the ANT/CABLE input is
configured for Cable will take substantially longer than when the
antenna input is configured for Antenna. This is normal;
however, once channel programming is finished, you should not
have to repeat the programming process again unless your
Cable TV service lineup changes significantly.
To program channels automatically:
1 Configure the antenna input source, if you have not already
done so, see “ANT/CABLE IN” on page 50.
2 Press the MENU button and open the Setup menu.
3 Highlight Installation, and then press the ENTER button.
(Sample Image) Setup menu - Installation selection
NOTE