Sharp 10P02-MX-NM Flat Panel Television User Manual


 
8
QUICK REFERENCE
Using the Remote Control Unit
Use the remote control unit by pointing it towards the
remote control sensor on the TV. Objects between the
remote control unit and the remote control sensor may
prevent proper operation.
30º 30º
30º
30º
17´ (5 m)
Remote control sensor
Cautions regarding the remote control unit
• Do not expose the remote control unit to shock. In addition,
do not expose the remote control unit to liquids, and do not
place in an area with high humidity.
• Do not install or place the remote control unit under direct
sunlight. The heat may cause deformation of the remote
control unit.
• The remote control unit may not work properly if the remote
control sensor on the TV is under direct sunlight or strong
lighting. In such cases, change the angle of the lighting
or the TV, or operate the remote control unit closer to the
remote control sensor.
IMPORTANT:
IF THE UNIT DOES NOT POWER ON - UNPLUG THE
TELEVISION FROM THE OUTLET AND REPEAT THE
INSTALLATION STEPS.
IF YOU STILL ENCOUNTER NO POWER, PLEASE CONTACT
US AT 1-800-BE-SHARP.
QUICK INSTALLATION TIPS
1
Attach your antenna to the back of the television.
(See page 9.)
2
Connect the AC plug for the television into the AC
outlet.
AC outlet
2
1
1
• Place the TV close to the AC outlet, and keep the power
plug within reach.
TO PREVENT RISK OF ELECTRIC SHOCK, DO NOT
TOUCH UN-INSULATED PARTS OF ANY CABLES
WITH THE AC CORD CONNECTED.
3
Bundle the cords properly with the cable clamp.
4
When turning on the TV for the fi rst time, press
POWER on the touch sensor panel on the front of
the TV.
POWER
5
Insert the batteries into the remote control unit. (See
page 9.)
• Speakers cannot be detached from the TV.
• The TV can be rotated up to 20 degrees to right and left.