Filter
Top Products
Connecting external devices
NOTE
• In cases when the decoder needs to receive a signal from
the TV, make sure to select the appropriate input terminal to
which the decoder is connected in “Input Source” (Page 10).
SCART connection
Example of connectable devices
● VCR ●
Decoder (only SCART 1)
●
DVD player/recorder
HDMI (DVI) Connection
ø 3,5 mm stereo mini jack cable
HDMI 1 or 2
HDMI-certified cable
DVI/HDMI Cable
PC connection through HDMI (DVI)
LC-37DH77E_ES.indd 16 2008/12/16 13:50:06
SCART 1
(AV / RGB)
Speaker/amplifier connector
Connect an amplifier with external speakers as shown
below.
Resolution
Horizontal
Frequency
Vertical
Frequency
VGA
640 g 480
31,5 kHz 60 Hz
VGA
720 g 400
31,47 kHz 70 Hz
SVGA
800 g 600
37,9 kHz 60 Hz
XGA
1.024 g 768
48,4 kHz 60 Hz
WXGA
1.360 g 768
47,7 kHz 60 Hz
SXGA
1.280 g 1.024
64,0 kHz 60 Hz
SXGA+
1.400 g 1.050
65,3 kHz 60 Hz
UXGA
1.600 g 1.200
75,0 kHz 60 Hz
1080p
1.920 g 1.080
67,5 kHz 60 Hz
PC compatibility chart
NOTE
• This TV has only limited PC compatibility, correct operation
can only be guaranteed if the video card conforms exactly
to the VESA 60 Hz standard. Any variations from this
standard will result in picture distortions.
VGA, SVGA, XGA, WXGA, SXGA, SXGA+ and
UXGA are registered trademarks of International
Business Machines Corporation.
15
0#
0#
LC-37DH77E_ES.indd 35 2008/12/16 13:50:34
AUDIO IN
HDMI (DVI)
SCART cable
Decoder
$)')4!,!5$)/).
SPDIF
SPDIF
DIGITAL
AUDIO
OUTPUT
Audio cable
Amplifier with digital
audio input
●
● After connection
● If after connecting a PC to the TV through a HDMI cable,
the audio does not run, connect a mini stereo connector of
ø 3.5mm between TV and PC as indicated in the previous
drawing.
●
When a PC is connected to the TV with a DVI cable, it
will be necessary to connect a mini stereo connector of ø
3.5mm of the TV to PC as indicated in the previous drawing
●
● After connecting
Digital audio output setting
After connecting an amplifier with digital audio input and
external speakers as shown, you should set an audio
output format compatible with the programme you are
watching or the device connected.
Go to “MENU” > “SOUND” > “SPDIF Mode” >
select “PCM” or “Dolby Digital”.
NOTE
• When you set this to “Dolby Digital”, and you receive
the Dolby Digital or Dolby Digital Plus audio formats,
Dolby Digital audio is output. Otherwise, PCM audio is
output.
When you set this to “PCM”, PCM audio is output no
matter what audio formats you receive.
Example of connectable devices
●
Connecting an amplifier with digital audio
input