Sharp LC-32FH500E CRT Television User Manual


 
Appendix
Troubleshooting
Problem Possible Solution
• No power.
Check if you pressed B on the remote control unit.
If the indicator on the TV lights up red, press B.
Is the AC cord disconnected?
Check if you pressed a on the TV.
The TV cannot be operated. External influences such as lightning, static electricity, etc., may cause improper operation. In this
case, operate the TV after first turning off the power, or unplugging the AC cord and re-plugging
it in after one or two minutes.
Remote control unit does not operate.
Are batteries inserted with polarity (e, f) aligned?
Are batteries worn out? (Replace with new batteries.)
Are you using it under strong or fluorescent lighting?
Is a fluorescent light illuminating to the remote control sensor?
Picture is cut off. Is the image position correct?
Are screen mode adjustments (Aspect ratio) such as picture size made correctly? (Page 20.)
Strange colour, light colour, or dark
colour, or colour misalignment.
Adjust the picture tone.
Is the room too bright? The picture may look dark in a room that is too bright.
Check the “PICTURE” setting (Page 17).
Power is suddenly turned off. The TV’s internal temperature has increased.
Remove any objects blocking the vent or clean.
Is the “Sleep Timer” set? Select “Off” from the “TIME” menu (Page 18).
Is “No Signal Off” or “No operation Off” activated?
No picture. Are connections to external equipment correct? (Pages 13, 14 and 15)
Is the input signal type selected correctly after connection? (Page 10)
Is the correct input source selected? (Page 10)
Is the picture adjustment correct? (Pages 17)
Is the antenna connected properly? (Page 8)
No sound. Is the volume too low?
Make sure that headphones are not connected.
Check if you pressed e on the remote control unit.
The TV sometimes makes a cracking
sound.
This is not a malfunction. This happens when the cabinet slightly expands and contracts
according to changes in temperature. This does not affect the TV’s performance.
Cautions regarding use in high and low temperature environments
• When the TV is used in a low temperature space (e.g. room, office), the picture may leave trails or appear slightly delayed.
This is not a malfunction, and the TV will recover when the temperature returns to normal.
• Do not leave the TV in a hot or cold location. Also, do not leave the TV in a location exposed to direct sunlight or near a
heater, as this may cause the cabinet to deform and the LCD panel to malfunction.
Storage temperature: -20 °C to e60 °C.
Information on the software license for this product
Software composition
The software included in this product is comprised of various software components whose individual copyrights are held by
SHARP or by third parties.
Software developed by SHARP and/or third part
The copyrights for the software components and various relevant documents included with this product that were developed
or written by SHARP are owned by SHARP and are protected by the Copyright Act, international treaties, and other relevant
laws. This product also makes use of freely distributed software and software components whose copyrights are held by third
parties.
This TV should be fixed on a wall only with the wall fix bracket available from SHARP (Page 5). The use of other wall
fix brackets may result in an unstable installation and may cause serious injuries.
Fixing the LCD colour TV requires special skills and should only be performed by qualified service personnel.
Customers should not attempt to do the work themselves. SHARP bears no responsibility for improper fixing or
fixing that results in accident or injury.
You can ask qualified service personnel about using an optional bracket to fix the TV on a wall.
To use this TV fixed on a wall, first remove the adhesive tape at the two locations on the rear of the TV, and then use the screws
supplied with the wall fix bracket to secure the bracket to the rear of the TV.
• When you fix the TV on a wall, you should attach the supporting post.
Fixing the TV on a wall
25