Filter
Top Products
30
Basic adjustment settings
No Signal off
When set to “Enable”, the power will automatically shut
down if no signal inputs for 15 minutes.
Press a/b to select “No Signal Off”, and
then press ENTER.
Press c/d to select “Enable”, and then
press ENTER
3
4
• Five minutes before the power shuts down,
remaining time displays every minute.
NOTE
• “Disable” is factory preset value.
• When a TV programme finishes, this function may not
operate.
Press c/d to select “Power control”.
• Power control menu displays.
2
Press MENU and the MENU screen displays.
1
No Operation off
When set to “Enable”, the power will automatically shut
down if there is no operation for 3 hours.
Press a/b to select “No Operation Off”, and
then press ENTER.
Press c/d to select “Enable”, and then
press ENTER.
3
4
• Five minutes before the power shuts down,
remaining time displays every minute.
NOTE
• “Disable” is factory preset value.
Press c/d to select “Power control”.
• Power control menu displays.
2
Press MENU and the MENU screen displays.
1
Power control
Power control setting allows you to save energy.
Power control for AV source
Power control for PC source
Power management
When set, the power will automatically shut down if no
signal is input for a certain time.
Press a/b to select “Power Management”,
and then press ENTER.
Press a/b to select “Mode1” or “Mode2”,
and then press ENTER.
3
4
Description
• No power management
• Factory preset value.
• If no signal inputs for 8 minutes, the power
shuts down.
• Even if you start using the PC and the signal
inputs again, the TV stays off.
• The TV turns on again by pressing POWER
on the TV or POWER on the remote control
unit. (See page 14.)
• If no signal inputs for 8 seconds, the power
shuts down.
• When you start using the PC and the signal
inputs again, the TV turns on.
• The TV turns on again by pressing POWER
on the TV or POWER on the remote control
unit. (See page 14.)
Selected item
Off
Mode1
Mode2
Press c/d to select “Power control”.
• Power control menu displays.
2
Press MENU and the MENU screen displays.
1
Off
Mode1
Mode2
NOTE
• When selecting “PC digital” in Input Select and setting
“Mode 2” in Power management, the power may not turn
back on automatically even if the signal inputs again.
LC-32_37GA4X(E)-e 04.9.17, 7:49 AM30