Filter
Top Products
12
-
Channel Setting
NOTE
• You may be prompted to select your local cable
operator before running the cable scan mode.
3. Press to select Scan type, and press
to select Quick Scan or Full Scan.
4. Press to select Start Frequency, End
Frequency, Modulation, Symbol Rate or Network
ID, and use digit buttons on the remote control to
define the information or select Auto for tuning.
5. When country was selected “Others” and ATV
system was selected, press to select
System, and press to select System.
6. Press to select Start Scan, and press OK to
start auto tuning.
NOTE
• The information should be given by your cable provider.
• Network ID is only available for Quick Scan.
Manual tuning
There are two TV modes: ATV and DTV that can be
tuned-in manually using Manual Tuning.
ATV Manual Tuning
Press MENU.
Press to select Setup, and press OK.
Press to select ATV Manual Tuning, and press
OK.
E Channel Sort
Channel Sort allows you to reorder the channels.
1. Press to select desired channel and press .
ATV Manual Tuning
Position
1
2
3
4
5
6
Channel
C1
C2
C3
C4
C5
C6
Station
ííííí
ííííí
ííííí
ííííí
ííííí
ííííí
Back
RETURN
Sort Enter
OK
2. Press to select the channel you wish to
swap and press .
The positions of the two channels are swapped.
Auto Tuning
Auto Tuning
The TV automatically detects and stores all available
services in your area. This function also allows you to
perform the channel setting for digital and analogue
individually and reconfigure the settings after the initial
auto installation has been completed.
Press MENU.
Press
to select Setup, and press OK.
Press to select Auto Tuning, and press OK.
E Tuner Mode - Antenna
1. Press to select ATV and DTV, DTV or ATV,
and press OK.
Auto Tuning
Tuning Mode
Start Scan
ATV and DTV
OK
Back
RETURN
Previous settings will be lost !
Press EXIT for no change.
Enter
OK
2. When country was selected “Others” and ATV
system was selected, press to select
System, and press to select system.
3. Press to select Start Scan, and press OK to
start auto tuning.
4. If you are able to receive broadcasts from
more than one region or transmitter you will be
prompted to choose via an OSD menu.
E Tuner Mode - Cable
1. Press to select ATV and DTV, DTV or ATV,
and press OK.
Auto Tuning
Tuning Mode
Start Scan
Operator Selection
Scan Type
Start Frequency (MHz)
End Frequency
Modulation
Symbol Rate
Network ID
ATV and DTV
Quick Scan
Auto
Auto
Auto
Auto
Auto
OK
Previous settings will be lost !
Press EXIT for no change.
Back
RETURN
Edit
2. Press to select Operator Selection, and
press to select Operator Selection.
SHARP_LE144E_Rev1_GB_English.indd 12SHARP_LE144E_Rev1_GB_English.indd 12 2012/09/13 17:43:592012/09/13 17:43:59