Filter
Top Products
7
Attaching/Detaching the Stand
• Before attaching (or detaching) the stand, make sure to
turn off the TV and unplug the AC cord.
• Before performing work spread cushioning over the base
area to lay the TV on. This will prevent it from being damaged.
CAUTION
• Attach the stand in the correct direction.
• Do not remove the stand from the TV unless using an
optional wall mount bracket to mount it.
•
Be sure to follow the instructions. Incorrect installation
of the stand may result in the TV falling over.
•
After attaching the stand to the TV, do not hold the
stand when you put up, set up, move or lay down the TV.
■
Attaching the Stand
1
Confi rm that there are 14 screws (all the same size)
supplied with the stand unit.
2
1
Set the post for the stand unit onto the
polystyrene foam.
2
Attach the base to the post.
3
Insert and tighten the 10 screws into the 10
holes on the bottom of the base.
• Hold the stand unit securely with one hand, and then
tighten the screws.
FRONT
2
1
1
Screws
3
1
Insert the stand into the openings on the bottom
of the TV.
• Make sure that the stand is fi rmly inserted into the TV.
Improper installation may result in tilting of the TV set.
2
Insert and tighten the 4 screws into the 4 holes
on the rear of the TV.
1
1
2
2
Soft cushion
Screws
■
Detaching the Stand
1
Unfasten the four screws used to secure the stand
in place.
QUICK REFERENCE
2
Detach the stand from the TV.
Setting the TV on the Wall
CAUTION
• This TV should be mounted on the wall only with the
wall mount bracket AN-52AG4 (SHARP). The use of
other wall mount brackets may result in an unstable
installation and may cause serious injuries.
• Installing the TV requires special skill that should
only be performed by qualifi ed service personnel.
Customers should not attempt to do the work
themselves. SHARP bears no responsibility for
improper mounting or mounting that results in
accident or injury.
Using an optional bracket to mount the TV
•
You can ask a qualifi ed service professional about
using an optional AN-52AG4 bracket to mount the TV
to the wall.
• Carefully read the instructions that come with the
bracket before beginning work.
Hanging on the wall
About setting the TV angle
Vertical mounting Angular mounting
• The center of the display:
1
63
/
64
inches (50.0 mm)
above the “ f ” position.
• Refer to the operation
manual of AN-52AG4 for
details.
AN-52AG4
0/5/10°
• Due to the terminal configuration on this TV, when you
wall-mount this model, make sure there is enough space
between the wall and the TV for the cables.
• To use this TV mounted on a wall, remove the covers at
the 4 locations on the rear of the TV, and then use the
screws supplied with the wall mount bracket to secure the
bracket to the rear of the TV.