Filter
Top Products
6
QUICK REFERENCE
Attaching the Stand
• Before attaching (or detaching) the stand, unplug the AC cord.
• Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from
being damaged.
CAUTION
• Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.
1
Confi rm that there are 11 screws (4 long screws,
4 middle screws and 3 short screw) supplied
with the stand unit.
2
Attach the supporting post for the stand unit
onto the base as shown below.
• The supporting post attaches to the base at an
offcentered location on the base. Be sure to attach
the supporting post in the direction indicated
below and attach the stand to the TV with the
wider side of the base facing forward.
Long screws
3
Insert the stand into the openings on the rear of
the TV.
• Make sure that the stand is fi rmly inserted into the TV.
Improper installation may result in tilting of the TV set.
Soft cushion
4
Insert and tighten the 4 screws into the 4 holes
on the rear of the stand unit.
Middle screws
5
1
Insert the stand cover.
2
Insert the 3 screws to secure the stand cover.
Short screws
• In the installation procedure, be careful not to catch your fi ngers between the
TV set and the fl oor.
• Do not remove the stand from the TV unless using an optional wall
mount bracket to mount it.
• After attaching the stand to the TV, do not hold the stand when you
put up, set up, move or lay down the TV.
QUICK INSTALLATION TIPS
1
Attach your antenna to the back of the television.
(See page 7.)
2
Connect the AC plug for the television into the
AC outlet.
• Place the TV close to the AC outlet, and keep the
power plug within reach.
1
1
2
AC outlet
Bundle the cords properly with the cable tie.
• When bundling the cords, use the AC cord holder
mounted on the TV. Relocate from
A
to
B
.
A
B
1
1
2
Remove and loosen
Attach and bundle together
NOTE
• TO PREVENT RISK OF ELECTRIC SHOCK, DO
NOT TOUCH UN-INSULATED PARTS OF ANY
CABLES WITH THE AC CORD CONNECTED.
3
When turning on the TV for the fi rst time, press
POWER on the television.
POWER
4
Insert the batteries into the remote control unit.
(See page 7.)
NOTE
• Speakers cannot be detached from the TV.
• The TV angle cannot be adjusted.
Experiencing HD Images
An HDTV without an HD source is just an ordinary TV.
To enjoy HD images on the TV, you should get
HD programming from the following:
• Over-the-air broadcasting via HD quality antenna
• HD cable/satellite subscription
• HD compatible external equipment
NOTE
• For information on updating to HD programming, ask
your cable/satellite service provider.