Filter
Top Products
35
NOTE
• When this function is not available, “NOT AVAILABLE”
will display.
• The still image automatically goes out after 30 minutes.
• If you are using the freeze function and a broadcast
activates the V-CHIP block, the freeze function will be
cancelled and a V-CHIP block message will appear.
Presetting remote control function
You can operate the connected AV products (AV
Receiver, Cable Box, SAT tuner, DTV, VCR, DVD,
LD) using the presetting manufacturer function of your
remote control unit.
Press FREEZE again to cancel the
function.
Other viewing options
Freezing images
Allows you to capture and freeze an image from a
moving image that you are watching.
Press FREEZE.
• A moving image is captured.
Presetting manufacturer codes
After the LED for your device lights up,
press FUNCTION and DISPLAY at the
same time to enter the code registration
mode. The LED will blink.
Press FUNCTION until the LED for your
device lights up.
After registering the code, the LED will stop
blinking then turn off after one second. (If
you perform an incorrect operation, the LED
will blink quickly then turn off.)
Press 0–9 to enter the manufacturer code.
(See page 36.)
• Preset mode is fi nished once the LED no
longer lights up.
1
2
1
2
4
3
SIGNAL METER
CHANNEL (DIGITAL) 23.002
40
Signal meter
In order to receive digital air broadcasts, you need a
digital broadcast antenna. You can confi rm the antenna
confi guration through the “SIGNAL METER” menu.
If necessary, adjust the direction of the antenna to
obtain the maximum signal strength.
Signal strength
Press MENU and the MENU screen
displays.
Press / to select (SETUP).
Press / to select “SIGNAL METER”.
Press /.
• The strength of the digital signal is displayed.
The signal information is based on the current
channel.
1
2
3
4
Press EXIT to return to the normal screen.
5
3Y10101A.indb 353Y10101A.indb 35 2006/01/19 20:30:402006/01/19 20:30:40