Filter
Top Products
15
Language
Standby Mode
Air/Cable
CH Search
English
Español
Français
Language
Standby Mode
Air/Cable
CH Search
Mode 1
Mode 2
AIR Analog & Digital Yes
CABLE Analog
No
Yes No
CABLE Analog & Digital
Yes No
Language
Standby Mode
Air/Cable
CH Search
Search Start
CH Search
ANALOG [ ]25 [ ]20
FoundAir
CH Search
DIGITAL [ ]25 [ ]20
FoundAir
2
Air ANALOG
Audio : MONO
Air/Cable
Standby Mode
Language
CH Search
Air
Cable
Initial setup
When you turn on the TV for the fi rst time, it will automatically memorize the broadcasting channels where you live.
Perform the following steps before you press POWER on the remote control unit.
1. Insert the batteries into the remote control unit. (See page 8.)
2. Connect the antenna cable to the TV. (See page 13.)
3. Plug in the AC cord to the AC outlet. (See page 7.)
Language setting
Select from among 3 languages: English, French and
Spanish.
Press
a
/
b
to select the desired language
listed on the screen, and then press ENTER.
Channel search
Channel auto search makes the TV look for all channels
viewable in the set area.
Press
c
/
d
to select “Yes” for AIR Analog &
Digital, then press
b
to move down.
Press
c
/
d
to select “Yes” or “No” for
CABLE Analog, then press
b
to move down.
Press
c
/
d
to select “Yes” or “No” for
CABLE Analog & Digital, then press
b
to
move down.
Select “Search Start”, and then press
ENTER.
• If you are only receiving an analog signal through
the cable, select “Yes” for CABLE Analog. If you
are receiving both an analog signal and a digital
signal through the cable, select “Yes” for CABLE
Analog & Digital.
Example
Standby Mode setting
Select the standby setting. (See page 30.)
Antenna setting
Make sure what kind of connection is made with your
TV when selecting “Air” or “Cable”.
Press
c
/
d
to select “Air” or “Cable”.
Press ENTER to enter the setting.
Mode 1: Starting TV is quick from standby.
Mode 2: Power consumption is small at the standby.
Example
Watching TV
1
2
3
4
NOTE
• If no channel is found, confi rm the type of connection made
with your TV and try EZ setup again. (See page 20.)