Filter
Top Products
— 23 —
KV-32FV27 / 36FS13 / 36FS17 / 36FV27 / 38FS17
H. SIZE ADJUSTMENT (HSIZ)
1. Input a monoscope signal.
2. Set to Service Adjustment Mode.
3. Select HSIZ with
1
and
4
.
4. Adjust with
3
and
6
for the best vertical size.
5. Write into the memory by pressing
MUTING
then
ENTER
.
H. POSITION ADJUSTMENT (HPOS)
HPOS Range is from 0~15.
1. Input a monoscope signal.
2. Set the Service Adjustment Mode.
3. Select HPOS with
1
and
4
.
4. Adjust with
3
and
6
for the best horizontal center.
5. Write into the memory by pressing
MUTING
then
ENTER
.
V LINEARITY (VLIN), V CORRECTION (VSCO),
PIN AMP (PAMP) AND PIN PHASE (PPHA)
ADJUSTMENTS
1. Input a cross-hatch signal.
2. Set to Service Adjustment Mode.
3. Select VLIN, VSCO, PAMP, and PPHA with
1
and
4
.
4. Adjust with
3
and
6
for the best picture.
5. Write the memory by pressing
MUTING
then
ENTER
.
V LINEARITY(VLIN)
VS CORRECTION (VSCO)
PIN AMP (PAMP)
PIN PHASE (PPHA)
V ANGLE (VANG), V BOW (VBOW), UPPER
PIN (UPIN) AND LOW PIN (LPIN)
ADJUSTMENTS
1. Input a monoscope signal.
2. Set to Service Adjustment Mode.
3. Select VANG, VBOW, UPIN, and LPIN with
1
and
4
.
4. Adjust with
3
and
6
for the best picture.
5. Write the memory by pressing
MUTING
then
ENTER
.
V ANGLE (VANG)
V BOW (VBOW)
UPPER PIN (UPIN)
LOW PIN (LPIN)
OSD POSITION ADJUSTMENT (DISP)
1. Input a color-bar signal.
2. Set to Service Adjustment Mode.
3. Select DISP with
1
and
4
.
4. Adjust with
3
and
6
for adjustment of characters to center.
5. Write the memory by pressing
MUTING
then
ENTER
.
OP 0 16 Service
DISP TV