Filter
Top Products
67
US
BDV-N9200W/BDV-N7200W/BDV-N5200W
4-485-799-12(1)
D:\NORM'S JOB\SONY HA\SO130077\BDV-N9200_7200_5200_E3200
(PMRF 01)\4485799121_US (U2)\100ADD.fm
masterpage:
Right
Additional Information
The dark area of the picture is too dark/
the bright area is too bright or
unnatural.
t Set [Picture Quality Mode] to [Auto]
(default) (page 41).
Picture noise appears.
t Clean the disc.
t If the picture output from your
system goes through your
equipment to get to your TV, the
copy-protection signal applied to
some BD/DVD programs could
affect picture quality. If you still
experience problems even when
you connect your main unit directly
to your TV, try connecting your main
unit to the other input jacks.
An image is not displayed on the entire
TV screen.
t Check the setting of [TV Type] in
[Screen Settings] (page 54).
t The aspect ratio on the disc is fixed.
Color irregularity occurs on the TV
screen.
t If the speakers are used with a CRT-
based TV or projector, install the
speakers at least 0.3 meters (1 foot)
from the TV set.
t If the color irregularity persists, turn
off the TV set once, then turn it on
after 15 to 30 minutes.
t Make sure that no magnetic object
(magnetic latch on a TV stand,
health care device, toy, etc.) is
placed near the speakers.
There is no sound.
t The speaker cords are not
connected securely.
t Check the speaker settings
(page 47).
The Super Audio CD sound of an
equipment that is connected to the
HDMI (IN 1) or HDMI (IN 2) jack is not
output.
t HDMI (IN 1) and HDMI (IN 2) does not
accept an audio format that
contains copy protection. Connect
the analog audio output of the
equipment to the AUDIO IN (L/R)
jacks of the main unit.
There is no sound from the TV via the
HDMI (OUT) jack when using the Audio
Return Channel function.
t Set [Control for HDMI] in [HDMI
Settings] of [System Settings] to
[On] (page 59). Also, set [Audio
Return Channel] in [HDMI Settings]
of [System Settings] to [Auto]
(page 59).
t Make sure that your TV is
compatible with the Audio Return
Channel function.
t Make sure that an HDMI cable is
connected to a jack on your TV that
is compatible with the Audio Return
Channel function.
The system does not output sound of
TV programs correctly when connected
to a set-top box.
t Set [Audio Return Channel] in [HDMI
Settings] of [System Settings] to
[Off] (page 59).
t Check the connections (page 23).
Severe hum or noise is heard.
t Move your audio equipment away
from the TV.
t Clean the disc.
The sound loses stereo effect when
you play a CD.
t Select stereo sound by pressing
AUDIO (page 43).
Sound