Filter
Top Products
55
Connections for an A/B Roll Editing System
Chapter 5 Connections and Settings
Video/audio signal connections
The following shows an example of video/audio signal
connections in an A/B roll editing system.
In this example, analog component signals are used as the
video signals and XLR 3-pin connectors are used as audio
input/output connectors.
For details of the video/audio input and audio mode
settings, refer to the instruction manuals for the devices
used.
VIDEO INPUTS
COMPONENT 2
VIDEO INPUTS
COMPONENT 1
COMPONENT VIDEO OUT
Y, R–Y, B–Y
COMPONENT VIDEO IN
Y, R–Y, B–Y
PGM OUT
COMPONENT 1
AUDIO IN
CH-1
CH-2
LINE OUT 2 LINE OUT 1
1234MIC/LINE
IN
AUDIO OUT
CH-1 CH-2
COMPONENT 1
OUTPUT
AUDIO OUTPUT
CH-1
CH-2
CH-2 OUTCH-1 OUT
CH-2 INCH-1 IN
1
1
2
3
3
3
3
3
3
3
3
DME switcher
(DFS-500/500P, etc.)
C Cable with XLR
connectors (not
supplied)
Audio mixer
(MXP-290, etc.)
DSR-1800A/
1800AP (recorder)
UVW-1600/1600P, etc. (player 2)
A 12-pin/3-BNC cross
cable
(not supplied; consult
your Sony dealer about
this cable.)
DSR-1600A/
1600AP (player 1)
DPS-D7 or other delay unit
B 12-pin dubbing cable
(not supplied)
Settings on the DSR-1800A/1800AP
Switch/menu Setting
AUDIO IN LEVEL/600
Ω
switches
HIGH-ON
LEVEL SELECT menu item Normally +4 dBm (see page
43)