Filter
Top Products
Editing
40
EN
Preparation
On the player
• Insert a source tape.
• If the player VCR has an EDIT switch, set it to “ON.”
• Set LANC MODE to “S.”
• Turn off the on-screen display.
On the recorder (this VCR)
• Insert a recorded tape.
• Press INPUT SELECT so that the jack to which the player is
connected appears in the display window:
"DV," "L1," or "L2
• Set LANC MODE to “M.”
• Set SHUTTLE MODE.
A: When slow playback in reverse direction is not available on the
other VCR.
B: When slow playback in reverse direction is available on the other
VCR.
• When you connect to the LINE-1 IN or LINE-2 IN jacks, set the audio
recording mode to “16 (bit)” (Fs48k) or “12 (bit)” (Fs32k).
When you are going to do insert recording, select the audio recording
mode of the recorded tape.
• When you connect to the LINE-1 IN or LINE-2 IN jacks, adjust the
recording level and balance with the REC LEVEL and REC
BALANCE controls.
Play back the source, then adjust the controls so that the red
indicators of the level meter (page 13) in the display window do not
light up. Select the balance according to your need (normally, set it to
the center).
When using this VCR as the playback machine
In the following pages, editing procedures using this VCR as the
recording machine are explained. To use this VCR as the playback
machine, note the following.
• When connecting the LANC jack, set LANC MODE to “S” in the SET
UP MENU. (page 21)
• If the other equipment that controls this VCR has the time code
function, press COUNTER SELECT on this VCR so that the time code
counter appears in the display window. (page 14)
• When you play back an audio dubbed tape and connect the other
VCR (recorder) to this VCR’s LINE OUT jacks, set the AUDIO
MONITOR selector to “MIX.” Then select the precise balance
between the tracks with the AUDIO MIX BALANCE control. (page
11)
For further instructions on editing, refer to the instruction manual of the
recording VCR or editing controller.
Connections and preparation
(continued)
Tips
• Editing is not possible with
a tape that is copyright
protected.
• LANC mode of camcorders
are usually fixed to “S.”
• For the DSR-200/200P
digital video camera
recorder, set SHUTTLE
MODE to “B.”
Notes
• The REC LEVEL and REC
BALANCE controls do not
function on a source input
through the DV jack.
• With the DV connection,
the playback VCR’s
AUDIO MONITOR (sound
selection) and AUDIO MIX
BALANCE (audio balance
adjustment) do not
function on the source
audio output through the
DV jack.