Filter
Top Products
38
EN
Dolby Digital Surround
Speaker Placement
For the best possible surround sound, we recommend
the following conditions.
• Use higher performance speakers.
• Use rear and center speakers that match your front
speakers in size and performance.
• All speakers should be the same distance from the
listening position.
• Place the subwoofer between the front (L, R)
speakers if possible.
Note
Do not place the center or rear speakers farther away from the
listening position than the front speakers.
SET UP
ENTER
?/>/.//
Symbol
5. 1 OUTPUT SETUP 1
SPEAKER SETUP
FRONT
REAR
ENTER
QUIT
SETUP
SUBWOOFER
DISTANCE
FRONT
3. 0m
CENTER
CENTER
REAR
3. 7m
3. 7m
10ft
12ft
12ft
1 212
Speaker Set Up
To obtain the best possible surround sound, first
specify the type of speakers you have connected and
their distance from your listening position. Then use
the test tone to adjust the speaker volumes to the same
level.
Specifying the speaker type
1 Press SET UP and select “
1
”, then press ENTER.
2 Select the speaker you want to adjust in
“SPEAKER SETUP” and press ENTER.
3 Select the appropriate symbol for the speaker, then
press ENTER.
Note
When you select a symbol, the sound cuts off for a moment.
pFront speaker, Center speaker, or Rear speaker
Generally, if you are utilizing large, full-range
speakers that effectively reproduce bass
frequencies, select this symbol. This is default
setting.
If you are utilizing small speakers with minimal
bass response, the sound distortion occurs, or
the effects of the surround is difficult to hear,
select this symbol.
If you will not connect the speaker, select this
symbol. You cannot select this symbol for the
front speakers.
The above speaker selections will activate the Dolby
Digital bass redirection circuitry and output the bass
frequencies to the appropriate speakers.
p Sub woofer
If you connect a sub woofer, select this symbol
to output the LFE (low frequency effects)
channel from the sub woofer. This is default
setting.
If you do not connect a sub woofer, select this
symbol. This activates the Dolby Digital (AC-3)
bass redirection circuitry and outputs the LFE
signals from other speakers.
Notes
• The cut off frequency for the subwoofer is fixed at 100Hz.
• Set the subwoofer‘s cut off frequency as high as possible.
• Depending on the settings of other speakers, the subwoofer
may output excessive sound.
• The bass management options provided by the bass
redirection circuitry in this player will optimize system set-
up based on total system configuration selected. In some
instances, independent speaker selections might be changed
to reflect the most optimum multi-channel sound
experience.
• If your speakers are too small to reproduce low bass
frequencies, please set all speaker settings to “ (small)”
and utilize a subwoofer for low frequency sound.