Filter
Top Products
18
Operating Instructions
Connecting a TV, VCR, and Satellite Receiver
1 Connect the coaxial cable from your satellite antenna to SATELLITE IN on the satellite
receiver.
2 Connect the coaxial cable from your cable service or antenna to the IN jack on your VCR.
3 Using a coaxial cable (not supplied), connect the OUT jack on your VCR to the VHF/UHF
jack on your TV.
4 Using audio/video cables (not supplied), connect AUDIO/VIDEO OUT on your satellite
receiver to AUDIO/VIDEO IN on your VCR.
5 Using audio/video cables (not supplied), connect AUDIO/VIDEO OUT on your VCR to
AUDIO/VIDEO IN on your TV.
Using your TV with this connection
This connection allows you to do the following:
❏
Program your Sony remote control to operate your VCR or satellite receiver (
see page 5
).
❏ Turn on your VCR to enable your satellite receiver to work with this connection.
❏ To activate your remote, press to operate your VCR or to operate your satellite
receiver.
❏ Press repeatedly to switch between VCR input (VIDEO input), VHF/UHF
(local channels or unscrambled), or your cable box (cable system or scrambled channels).
✍ To view from the satellite receiver or VCR, select the video input to which your satellite receiver or
VCR is connected by pressing on the remote control.
1
3
4
5
MONITOR
AUDIO OUT
(VAR/FIX)
VIDEO
L
(MONO)
R
L
R
(MONO)
VIDEO
S VIDEO
Y
PB
PR
2
From
cable/
antenna
3
Satellite receiver
1
4
5
VCR
Rear of TV
Audio R (red)
Audio L (white)
Video (yellow)
01US01COV-BR2.book Page 18 Wednesday, February 19, 2003 5:45 PM