Filter
Top Products
TV menu system
29
Further Programme Preset menu
(for analogue channels only)
To check which mode you are in, press the button on the remote control. If you are
watching a digital programme, an Info display appears on screen providing brief details
for the current and next programme. If this happens, press the DIGITAL/ button on
the remote control to switch to analogue channels.
The ‘Further Programme Preset’ option in the ‘Manual Set Up’ menu allows you to
obtain a better picture if there is interference, set the volume level of an individual
channel, fine tune the TV and set up a channel for viewing signals from a Decoder. With
the ‘Further Programme Preset’ option highlighted, press b to enter the ‘Further
Programme Preset’ menu. Press v or V to highlight the channel number you require.
Press b repeatedly to select one of the following options:
(a) ATT (RF Attenuator). This allows you to improve the picture if there is interference
from other channels. Press v to select On. Press OK to store.
(b) VOL (Volume Level Offset). This allows you to set the volume level for an
individual channel. Press v or V to adjust the volume level over a range of -7 to
+7. Press OK to store.
(c) AFT (Automatic Fine Tune). This allows you to fine tune a channel. Press v or V
to select On. Alternatively, press v or V to manually adjust the tuning frequency
over a range of -15 to +15. Press OK to store.
(d) DECODER. This allows you to set a channel for viewing scrambled signals (e.g.
from a pay TV decoder). Press v or V to select AV1 or AV3 depending on which
socket the equipment is connected to. Press OK to store. The unscrambled signal
now appears on the selected channel.
OK
DIGITAL
DIGITAL
NX 24-33.fm Page 29 Monday, September 16, 2002 2:04 PM